Use 18 ga 1 1 2 long staples when installing thinner 1 2 thick solid wood floors per manufacturer s recommendation.
Flooring staples not going in far enough.
Going for the staples.
One of the floor guys i use from time to time gave me a bostich miii.
Then you may use an edger nails gun or nail down manually.
To test your spring open the stapler slide it back and let go.
It is not pushed down on as this will cause gouging.
Hardwood cleats don t go in the plank far enough i have been working on hardwood floor project and the bostitch manual floor nailer couldn t drive the nail in all the way.
I went from 2 to 1 1 2 staples and it didn t make a difference.
Which brings me to my original struggle not sure if 2 inch or 1 3 4 inch is better.
On your last rows you may won t be able to use the stapler because there will be not enough space between the boards and the wall.
Use 15 ga 1 3 4 long staples when installing 3 4 solid wood flooring when 3 4 plywood is applied directly over a concrete slab so that the staple does not go through the 3 4 plywood hitting the concrete.
Using a stapler with 1 1 2 to 2 staples is one method to attach wood flooring to your subfloor.
It s practically new but i can seem to get the staples to sink far enough.
I have little experience with pneumatic cleat guns but i know they have a piston big enough to sink the dog scat out of a lil ole cleat.
When used improperly staples or cleats can damage wood flooring.
I stay around 80 pounds.
I know i wont do 1 1 2.
If the tool is not adjusted properly the staples cleats may not be positioned at the proper angle and cause blistering peaking squeaking or crackling of the floor.
Some models may require the use of an adapter to adjust for proper thickness.
At 105 pounds you should be shooting cleats into the basement.
It has a 5 6 foot long handle on it and is just allowed to glide across the floor.
I had to set tons of staples to get the boards close and.
I also use the bostich m 111.
The spring should rapidly contact the bar of staples.
Take it back and get a new one.
I tried regular bruce hardwood at my house to get a feel for the gun.
The heavy headed or weighted scraper is run across the floor in a regular scraping fashion.
Don t know how far down the tongue is so a little less than 2 12 inches at nailing point.
Attempting to nail down a wooden floor by hand is not recommended for a number of reasons including consistency and accuracy.
Nwfa specifies 2 but i am worried about the penetration out the back of the osb yet i am worried that 1 3 4 wont be enough.
The air driven pneumatic nailer will produce enough force to ensure the fastening is tightly secure.
If the spring s reaction is slow or not forceful enough a replacement is needed.
